gogetit

Hello, I have a problem with Opel Zafira C 2014 year. I changed the BCM module, because the car was flooded. The new one is learned to the car, but don't control the headlights correctly, the car is equipped with Xenon lights The BCM output not control the relay for the low beam. I cannot find any tool to configure the new BCM. I bought one more BCM from a car with Xenon ligtsm but the module acts as mine. How can I do configuration of the BCM ? Which tool can change the configuration of the BCM module ? I tried with OP Com, Autel and Launch, but there is no this option.

Hello, I have a problem with my Zafira C 2.0 CDTI, the car runs well at low revs, but when hold the engine in high revs the check light comes up and car goes in limp mode. ECU stores P2270 fault - MAF sensor performance. I removed the MAF from the car and clean it, also checked all pipes and didnt find any leaks. I checked the MAF values in live data and seems ok, but I noticed that MAP sensor actual values values are lower than desired from the ECU. Also checked for the leaks around the MAP sensor, but cound''t find. I would appreciate any help if anyone is faced with that problem.

Hello colleagues, I have a problem with my Meriva 1.7 cdti 2006 year, wont start. There is no faults stored in the ECU or other modules. I checked synchronisation of camshaft and crankshaft with osciloscope and looks fine.There is fuel to rail, but dont come signals to the injectors. I cant find when supply to the injectors must come. Is the supply have to come to the injectors after ignition on or when the starter is engaged? I tried with other ECU, but the results is the same no signals to the injectors. There is enough rail pressure, I checked it with OP com.